Structural Glazing
Glass held by structural bonding — a continuous, frameless outer surface.
Architectural Aluminium & Glass Facade Systems.
BEYONDTHE SURFACE.
Precision aluminium engineering and structural glazing for architecture that is meant to last.
Aluminium-glass facade · AssemblyCGI film · drag to rotate once assembled
Beyond the surface
A facade is not a finish. It is the building's engineered skin.
Every facade negotiates light, weather, structure and proportion at once. ALUSET approaches aluminium and glass as a single architectural system — where extrusion geometry, glazing and detailing are resolved together, not assembled afterwards.
The result is a surface that reads as calm and inevitable from the street, and that performs with precision for decades behind it.
- 01
Engineered, not decorated
Profiles, fixings and joints are designed as one coordinated system.
- 02
Precision at every scale
From site survey to the final gasket, tolerances are planned, not improvised.
- 03
Architecture first
The system serves the architect's intent — never the other way around.
Facade systems
System families for architectural envelopes.
The system categories below describe the architectural facade families ALUSET works within. Specific product lines are confirmed per project.
Curtain Wall Systems
A self-supporting aluminium grid of mullions and transoms carrying glass and panels.
Aluminium Composite Panels
Flat, precise aluminium-faced panels for crisp opaque surfaces and details.
Ventilated Facades
A rain-screen outer layer with a ventilated cavity over insulation.
Architectural Louvers
Aluminium blades that shape light, air and privacy.
- Start a Project
A different envelope in mind?
Hybrid systems and special conditions are reviewed per project.
Start a Project
Engineering precision
View EngineeringResolved in detail before it is built in aluminium.
Facades fail at the joint, not at the panel. ALUSET's methodology concentrates engineering attention where it matters: interfaces, movement, water management and thermal continuity.
- 01
Survey & geometry
Existing structure is measured and modelled so the facade grid is set out against reality, not drawings alone.
- 02
Detailing
Every typical and atypical condition is drawn: corners, parapets, slab edges, transitions between systems.
- 03
Movement & tolerance
Thermal expansion, structural deflection and installation tolerance are accommodated by design.
- 04
Water & air
Drainage paths, pressure equalisation and gasket continuity are coordinated across the full envelope.
Facade experience
Configure the surface. See it in light.
An interactive facade configurator: system type, aluminium finish, glass appearance and lighting — rendered as a real-time 3D facade sample.
Open Facade ExperienceLive 3D facade sample · WebGL
Architectural capabilities
From the first sketch to the sealed joint.
A facade project moves through clearly defined stages. Scope for each stage is agreed with ALUSET per project.
- 01
Consultation & concept
Early-stage input on system selection, module rhythm and feasibility.
- 02
Technical detailing
Shop drawings, interface details and coordination with the structural design.
- 03
Fabrication coordination
Aluminium profiles, finishes and glazing units specified and coordinated for production.
- 04
Installation & handover
Sequenced site installation with quality control and documented handover.
Projects
Built surfaces.
Verified ALUSET facade projects will be published here as they are documented and approved.
Portfolio in preparation
No projects are published yet. Conceptual demonstrations are shown on the Projects page and are clearly marked as studies.
Start your project
Tell us about the building.
Share the location, scale and stage of your project. ALUSET will respond with the right next step — a conversation, a site visit or a technical review.